Confused how to set up a repeater device? Searched various articles but found it difficult to complete the setup by yourself. It’s not actually, you can configure the device by yourself very easily if you are aware of the setup process. Here you will find a step by step guide to perform Wavlink Wifi Repeater Setup to boost your home wireless network coverage. Whether you proceed with a WPS button based method or go with Web based setup, a guide for both methods is mentioned. In addition to this we also specify how you can install the hardware of the device. To get adequate knowledge you need to read the article without skipping any of the steps.
Installation of Repeater
Installation of the repeater device begins with the unboxing of the device. You need to carefully take out the repeater and check for physical damage. If everything is perfect then start looking for a position to put the device. Make sure the device is closer to the host networking device. If the repeater is too far from the host device then you might experience trouble in configuring the device. After placement of the repeater you need to connect it with power. To power it up, plug the device into a power outlet with the help of a power cable or power adapter as per your device. Wait for it to boot up and then initiate the Wavlink Wifi Repeater Setup using any of the below given processes.
Configure Using Web
Wavlink Wifi Repeater Setup using web is simple and easy if you follow the below given steps:
- Initiate the configuration using the web by choosing a client device.
- After selecting the device you have to connect it with the repeater network via ethernet cable or via WiFi network details.
- Once the connection is established, launch a web browser to open the setup page.
- Use IP address or web address to open the setup page and then specify the default login details to gain the access.
- Click the login option and the user dashboard will open on the screen from where you have to connect the repeater with the host router.
- For connection you have to select the network name of the repeater device.
- After that the screen will ask you to enter the password you need to mention and save settings.
- Move forward and then replace the default network name and password.
- Make other significant changes, save the settings and relocate the repeater device.
- Don’t forget to test the network after the configuration is done by you.
Configure via WPS
Wavlink Wifi Repeater Setup using WPS is simple and easy if you follow the below given steps:
- To initiate the process you have to locate the WPS button on both the devices.
- After locating the button, click on the repeater button first, hold it for a while and then release it.
- In the next 2 minutes you have to press the button on the host router device and hold it for a while.
- Release the button and keep an eye on the repeater device LED behaviour.
- Its LED will help you understand whether the connection is done successfully or not.
- If it turns red then your setup fails and if it turns solid green/ blue then setup is successful.
- In case the process fails then you can try again to configure the repeater device.
- Don’t forget to test the network after the configuration is done by you.
Conclusion
At last I would like to conclude my words by saying that Wavlink Wifi Repeater Setup is very easy using both the methods. You can follow any of the methods as per your convenience. Both methods have their own significance. If you follow WPS based connections then you can quickly configure the device and enjoy better network coverage. Whereas if you choose a web based method then you can customize your repeater network and make adjustments in the settings as per your requirement. If you face a problem in setting up even after carefully following the above steps then you need expert help. An expert can guide you better to complete the configuration and enjoy high speed networks.